Ht-instruments XL424 Instrukcja Użytkownika

©Copyright HT ITALIA 2005 Release EN 1.00 - 03/10/2005 ENGLISH User’s manual

XL423 - XL424 EN - 96.2 USING THE INSTRUMENT IN A THREE PHASE 4-WIRES PLANT WARNING The Instrument can be used in installation with over

XL423 - XL424 EN - 106. During a Recording: • A STATUS LED 3 seconds blinking meaning that the recording is active and the instrument is sto

XL423 - XL424 EN - 116.3 USING THE INSTRUMENT IN A THREE PHASE 3-WIRES PLANT WARNING The Instrument can be used in installation with over

XL423 - XL424 EN - 125. How to start a Recording: • If no recording was performed or if the recording data was already downloaded to a PC, p

XL423 - XL424 EN - 137 LED MESSAGES DESCRIPTION For the STATUS and ALARM LEDs messages please refer to the following table: LED START/STOP K

XL423 - XL424 EN - 149 MAINTENANCE 9.1 GENERAL INFORMATION This instrument is a precision instrument. Whether in use or in storage, please do

XL423 - XL424 EN - 1510 TECHNICAL SPECIFICATIONS This product conforms to the prescriptions of the European directive on low voltage 73/23/EEC

XL423 - XL424 EN - 1610.3 ACCESSORIES Description Code Adhesive Velcro 50 x 70 cm VELCRO Set of 2 Black/Blue alligator clips (XL423 only) KI

XL423 - XL424 EN - 1INDEX 1. SAFETY PRECAUTIONS AND PROCEDURES...

XL423 - XL424 EN - 21. SAFETY PRECAUTIONS AND PROCEDURES This meter has been designed in compliance with EN 61010 directive. For your own safe

XL423 - XL424 EN - 31.2 DURING USE Carefully read the herewith recommendations and instructions: WARNING • Non compliance with warnings an

XL423 - XL424 EN - 42 GENERAL DESCRIPTION 2.1 INTRODUCTION Dear Customer, the instrument you have just purchased will grant you accurate and r

XL423 - XL424 EN - 53 PREPARATION FOR USE 3.1 PRELIMINARY CHECKS This instrument has been checked mechanically and electrically before shipm

XL423 - XL424 EN - 64 OPERATING INSTRUCTIONS 4.1 INSTRUMENT DESCRIPTION L1L1L2L3123465 LEGEND: 1. Phase Voltage Inputs 2. COM input 3. “ST

XL423 - XL424 EN - 76 MEASURING PROCEDURE 6.1 USING THE INSTRUMENT IN A SINGLE PHASE PLANT WARNING The Instrument can be used in install

XL423 - XL424 EN - 86. During a Recording: • A STATUS LED 3 seconds blinking meaning that the recording is active and the instrument is stor